If I am challenged with air temperatures, an inexpensive way to increase air flow is to put a free standing fan on the ledge of the inlet air or on the floor to force more inlet air into the
If dust grooves are worn, restore them to their original condition by regrooving the rings, provided the rings have enough thickness remaining. If insulation is grounded, remove and reinsulate rings. If
When discharging air vertically, because the generator is surrounded on all sides, can result in higher than ambient air temperatures being pushed into inlet vents.
Generator sets must be properly installed to ensure that cooling air is not restricted or artificially heated by nearby heat sources or from recirculation. Fortunately, installation influences can be simulated
In this method of cooling, inlet air to the compressor is cooled from ambient temperature to a lower temperature by means of an "ammonia-water" vapor absorption
Collector flashovers are a common cause of forced outage failures for operators of turbine generators. Collector flashover is also one of the most preventable of in-service failures.
The installer must make sure that the total square inches of free air inlet opening is sufficient to limit the heat rise in the room to prevent the room temperature from exceeding the generator ''s operating
Temperature of the collector inlet and outlet cooling air is monitored to gage collector ventilation performance. Important: Pay close attention to the OEM recommendations on temperature-rise limits.
Heating during operation is a common malfunction of the brushes and collector rings of Cummins diesel generator sets, which can affect the normal start-up and operation of Cummins
PDF version includes complete article with source references. Suitable for printing and offline reading.
